Chevrolet 10 Series 1970 Service Manual page 522

STEERING 9-14
s p e c ified during rea ssem b ly to assure p rop er
retention of these parts.
T ie Rod
Removal
1. P la c e ve h ic le on hoist.
2. R em ove cotter pins fro m ball studs and rem o ve cas­
tellated nuts.
3. T o rem o ve outer b a ll stud, tap on steerin g arm at
tie rod end with a ham m er while using a heavy ham­
m e r o r s im ila r tool as a backing (fig. 23).
On C -P 1 0 -2 0 -3 0 s e rie s ,
fro m rela y rod using sam e procedure as d escribed
in Step 2.
T o rem ove tie rod ends fro m tie rod loosen clam p
bolts and unscrew end assem b lies.
The tie rod sockets a re sealed units (except 11000#
a x le s) and cannot be disassem bled.
Disassembly ( 1 1 , 0 0 0 # Axles)
1. R em ove the seal and dust c o ver fro m the b a ll stud.
F ig . 2 2 — K 1 0 -2 0 Series S teering Linkage
rem ove inner ball stud
F ig . 23— B all Stud Removal (T y p ic a l)
P r y out the low er snap ring and rem ove the snap
2.
ring, end plug and spring.
3. Push the ball stud out of housing along with the
p la stic washer and ball stud bearing.
4.
R em ove the b all stud seat.
Inspection ( 1 1 , 0 0 0 # A xles)
1. U se a suitable solvent to thoroughly clean a ll parts.
W ipe or blow parts dry.
Inspect parts fo r w ear o r damage and rep lace if
2.
n ecessary.
3. Check the spring fo r distortion o r collapsed coils.
Assembly ( 1 1 , 0 0 0 # Axles)
1. In stall the b all stud seat o v e r the stud and install
both in the rod socket.
Install the bearing.
2.
3. In stall the p lastic w asher, being carefu l not to dam­
age o r d istort it.
4.
P la c e the spring in the housing; la rg e end of spring
against the bearing.
5. In stall the end plug and the snap ring, making sure
the snap ring is seated in the socket groove.
6. P la c e the dust co ve r and seal onto the threaded end
of the b a ll stud.
Installation
1. If the tie rod ends w ere rem oved, lu bricate the tie
rod threads with E P C hassis lube and in stall ends on
tie rod making sure both ends are threaded an equal
distance fro m the tie rod.
Make sure that threads on b a ll studs and in b a ll stud
2.
nuts a re p e rfe c tly clean and smooth.
tion of b a ll stud seals; rep la ce if n ecessary.
NOTE: If threads are not clean and smooth,
b a ll studs m ay turn in tie
tem pting to tighten nut.
3. In stall b a ll studs in steerin g arm s and re la y rod.
4.
In stall ball stud nut, tighten and in stall cotter pins.
Lu bricate tie rod ends.
5. R em ove veh icle fro m hoist.
6. Adjust to e-in as d escrib ed in Section 3.
Check condi­
rod ends when at­
CHEVROLET TRUCK SERVICE MANUAL