Show Power-Inline Interface - Allied Telesis AT-IX5-28GPX Manual

High availability, high power video surveillance poe switch

Hide thumbs Also See for AT-IX5-28GPX:

Table of Contents

INLINE INTERFACE

show power-inline interface

This command displays a summary of Power over Ethernet (PoE) information for

specified ports. If no ports are specified then PoE information is displayed for all

ports on the Power Sourcing Equipment (PSE).

For information on filtering and saving command output, see "Controlling "show"

Command Output" in the

and Configuration

show power-inline interface [<port-list>]

User Exec and Privileged Exec

To display PoE information for all PoE ports on the PSE, do not specify any ports.

To display the PoE port specific information for all PoE ports on the switch, use the

following command:

To display the PoE port specific information for the port range1.0.1 to 1.0.4,

use the following command:

Figure 14-4: Example output from the show power-inline interface command

awplus#show power-inline interface port1.0.1-port1.0.4

Disabled Low

Disabled Low

Table 14-3: Parameters in the show power-inline interface command output

Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch

Enter the PoE port(s) to display PoE specific information in the show

show power-inline interface

show power-inline interface port1.0.1-port1.0.4

Power Device

High Powered

3840 Desk Phone

Crit Powered

6720 AccessPoint 2

The PoE port(s) in the format portx.y.z, where x is the device

number, y is the module number within the device, and z is the

PoE port number within the module.

The administrative state of PoE on a PoE port, either Enabled or

AlliedWare Plus™ Operating System - Version 5.4.5-0.x

"Getting Started with AlliedWare Plus" Feature Overview

Class Max(mW)

C613-50057-01 REV A