Switchport Voice Dscp - Allied Telesis AT-IX5-28GPX Manual

VLAN C
OMMANDS

SWITCHPORT VOICE DSCP

switchport voice dscp
Overview Use this command to configure the Layer 3 DSCP value advertised when the
transmission of LLDP-MED Network Policy TLVs for voice devices is enabled. When
LLDP-MED capable IP phones receive this network policy information, they
transmit voice data with the specified DSCP value.
Use the no variant of this command to reset the DSCP value to the default, 0.
Syntax
switchport voice dscp <0-63>
no switchport voice dscp
Default A DSCP value of 0 will be advertised.
Mode Interface Configuration
Usage LLDP-MED advertisements including Network Policy TLVs are transmitted via a
port if:
•
•
•
•
•
Example
awplus#
awplus(config)#
awplus(config-if)#
Related lldp med-tlv-select
Commands
show lldp
switchport voice vlan
446 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Specify a DSCP value for voice data.
dscp
DSCP value.
<0-63>
LLDP is enabled (lldp run
Voice VLAN is configured for the port
The port is configured to transmit LLDP advertisements—enabled by default
(lldp transmit receive
The port is configured to transmit Network Policy TLVs—enabled by default
(lldp med-tlv-select
There is an LLDP-MED device connected to the port
configure terminal
interface port1.0.5
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
command)
(switchport voice vlan
command)
command)
switchport voice dscp 27
command)
C613-50057-01 REV A