Show Power-Inline Interface - Allied Telesis IE220 Series Manual

P E C
OWER OVER THERNET OMMANDS
-
SHOW POWER INLINE INTERFACE

show power-inline interface

Overview This command displays a summary of Power over Ethernet (PoE) information for
specified ports. If no ports are specified then PoE information is displayed for all
ports.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
show power-inline interface [<port-list>]
Syntax
Mode User Exec and Privileged Exec
Example To display the PoE port-specific information for all PoE ports on the switch, use the
following command:
awplus#
To display the PoE port specific information for port1.0.1 to port1.0.3, use the
following command:
awplus#
Output Figure 20-4: Example output from show power-inline interface
show power-inline interface

Interface/ Admin
Pair
port1.0.1/D Enabled
port1.0.2/D Enabled
port1.0.3/D Enabled
port1.0.4/D Enabled
...
Table 3: Parameters in show power-inline interface output
C613-50644-01 Rev B
Parameter Description
<port-list>
Enter the PoE port(s) to display PoE specific information in the show
output.
show power-inline interface
show power-inline interface port1.0.1-port1.0.3
Pri Oper
Low Powered
Low Off
Low Off
Low Off
Parameter Description
Interface
The PoE port(s) in the format port1.0.z, where z is the port
number. After the port number, "/D" indicates the data pair and
"/S" indicates the spare pair.
Admin
The administrative state of PoE on a PoE port, either Enabled or
Disabled.
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Power Device
(mW)
3271 n/a
0 n/a
0 n/a
0 n/a
"Getting Started
Guide.

Class Max
(mW)
4 30000 [C] 

n/a n/a

n/a n/a

n/a n/a
787