Egress-Rate-Limit - Allied Telesis AT-IX5-28GPX Manual

Q S C
O OMMANDS
- -
EGRESS RATE LIMIT

egress-rate-limit

Overview Sets a limit on the amount of traffic that can be transmitted per second from this
port.
Use the no variant of this command to disable the limiting of traffic egressing on
the interface.
Syntax
egress-rate-limit <bandwidth>
no egress-rate-limit
Mode Interface Configuration
Examples To enable egress rate limiting on a port, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
%
To disable egress rate limiting on a port, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Bandwidth <1-10000000 units per second> (usable units: k, m, g).
<bandwidth>
The egress rate limit can be configured in multiples of 64kbps. If
you configure a value that is not an exact multiple of 64kbps, then
the value will be rounded up to the nearest higher exact multiple
of 64kbps. The minimum is 64 Kb.
The default unit is Kb ( k), but Mb ( m) or Gb ( g) can also be
specified. The command syntax is not case sensitive, so a value
such as 20m or 20M will be taken as 20 megabits.
configure terminal
interface port1.0.1
Egress rate limit has been set to 64 Kb
configure terminal
interface port1.0.1
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
egress-rate-limit 64k
no egress-rate-limit
951