Ipv6 Mld Last-Member-Query-Count - Allied Telesis AT-IX5-28GPX Manual

MLD MLD S C
AND NOOPING OMMANDS
6 - - -
IPV MLD LAST MEMBER QUERY

ipv6 mld last-member-query-count

Overview Use this command to set the last-member query-count value.
Use the no variant of this command to return to the default on an interface.
Syntax
ipv6 mld last-member-query-count <value>
no ipv6 mld last-member-query-count
Default The default last-member query-count value is 2.
Mode Interface Configuration for a specified VLAN interface or a range of VLAN
interfaces.
Example
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
COUNT
Parameter Description
Count value. Valid values are from 2 to 7.
<value>
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
ipv6 enable
ipv6 mld last-member-query-count 3
797