(Access-List Standard Named Filter) - Allied Telesis AT-IX5-28GPX Manual

High availability, high power video surveillance poe switch

Hide thumbs Also See for AT-IX5-28GPX:

Table of Contents

LIST STANDARD NAMED FILTER

(access-list standard named filter)

This ACL filter adds a source IP address filter entry to a current named standard

access-list. If the sequence number is specified, the new filter entry is inserted at

the specified location. Otherwise, the new entry is added at the end of the

access-list.

The no variant of this command removes a source IP address filter entry from the

current named standard access-list. You can specify the source IP address filter

entry for removal by entering either its sequence number (e.g. no 10), or by

entering its source IP address filter profile without specifying its sequence number.

Note that the sequence number can be found by running the

Software ACLs)

[<sequence-number>] {deny|permit} {<source> [exact-match]|any}

no {deny|permit} {<source> [exact-match]|any}

no <sequence-number>

IPv4 Standard ACL Configuration

Any traffic controlled by a software ACL that does not explicitly match a filter is

Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch

<sequence-number>

AlliedWare Plus™ Operating System - Version 5.4.5-0.x

The sequence number for the filter entry of the

selected access control list.

Access-list rejects packets of the source filtering

Access-list allows packets of the source filtering

The source address of the packets. You can specify

either a subnet or all sources. The following are the

valid formats for specifying the source:

An IPv4 address, followed by a

forward slash, then the prefix

length. This matches any

destination IP address within

the specified subnet.

An IPv4 address in a.b.c.d

Specify an exact IP prefix to match on.

Matches any source IP address.

show access-list (IPv4

C613-50057-01 REV A