Ipv6 Mld Access-Group - Allied Telesis AT-IX5-28GPX Manual

MLD MLD S C
AND NOOPING OMMANDS
6 -
IPV MLD ACCESS GROUP

ipv6 mld access-group

Overview Use this command to control the multicast local-membership groups learned on
an interface.
Use the no variant of this command to disable this access control.
Syntax
ipv6 mld access-group <IPv6-access-list-name>
no ipv6 mld access-group
Default No access list is configured by default.
Mode Interface Configuration for a specified VLAN interface or a range of VLAN
interfaces.
Examples In the following example, the VLAN interface vlan2 will only accept MLD joins for
groups in the range ff1e:0db8:0001::/64:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
ff1e:0db8:0001::/64
awplus(config)#
awplus(config-if)#
awplus(config-if)#
In the following example, the VLAN interfaces vlan2-vlan4 will only accept
MLD joins for groups in the range ff1e:0db8:0001::/64:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
ff1e:0db8:0001::/64
awplus(config)#
awplus(config-if)#
awplus(config-if)#
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
<IPv6-access-list-
name>
configure terminal
ipv6 forwarding
ipv6 multicast-routing
ipv6 access-list standard group1 permit
interface vlan2
configure terminal
ipv6 forwarding
ipv6 multicast-routing
ipv6 access-list standard group1 permit
interface vlan2-vlan4
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
Specify a Standard or an Extended software IPv6
access-list name. See
(ACL) Commands for supported IPv6 ACLs.
ipv6 enable
ipv6 mld access-group group1
ipv6 enable
ipv6 mld access-group group1
IPv6 Software Access Control List
795