IGMP
IGMP S
C
AND
NOOPING
OMMANDS
-
IP IGMP MROUTE
PROXY
ip igmp mroute-proxy
Overview
Use this command to enable IGMP mroute proxy on this downstream interface and
associate it with the upstream proxy service interface.
Use the no variant of this command to remove the association with the
proxy-service interface.
Syntax
ip igmp mroute-proxy <interface>
no ip igmp mroute-proxy
Mode
Interface Configuration for a VLAN interface.
Usage
You must also enable the IGMP proxy service on the upstream interface, using the
ip igmp proxy-service
mroute proxy interfaces on the device with a single upstream proxy service
interface. This downstream mroute proxy interface listens for IGMP reports, and
forwards them to the upstream IGMP proxy service interface.
IGMP Proxy does not work with other multicast routing protocols, such as PIM-SM
or PIM- DM. This command applies to interfaces configured for IGMP Proxy.
Example
The following example configures the VLAN interface vlan2 as the upstream
proxy- service interface for the downstream vlan3interface.
awplus#
awplus(config)#
awplus(config-if)#
Related
ip igmp proxy-service
Commands
746
Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
<interface>
command. You can associate one or more downstream
configure terminal
interface vlan3
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
The name of the VLAN interface.
ip igmp mroute-proxy vlan2
C613-50057-01 REV A