Ip Igmp Last-Member-Query-Interval - Allied Telesis AT-IX5-28GPX Manual

IGMP IGMP S C
AND NOOPING OMMANDS
- - -
IP IGMP LAST MEMBER QUERY INTERVAL

ip igmp last-member-query-interval

Overview Use this command to configure the frequency at which the router sends IGMP
group specific host query messages.
Use the no variant of this command to set this frequency to the default.
Syntax
ip igmp last-member-query-interval <interval>
no ip igmp last-member-query-interval
Default 1000 milliseconds
Mode Interface Configuration for a VLAN interface.
Usage This command applies to interfaces configured for IGMP, IGMP Snooping, or IGMP
Proxy.
Example The following example changes the IGMP group-specific host query message
interval to 2 seconds (2000 milliseconds) for VLAN interface vlan1:
awplus#
awplus(config)#
awplus(config-if)#
Validation show ip igmp interface
Commands
show running-config
Related ip igmp immediate-leave
Commands
ip igmp last-member-query-count
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
The frequency in milliseconds, in the range <1000-25500>, at which
<interval>
IGMP group-specific host query messages are sent.
configure terminal
interface vlan1
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
ip igmp last-member-query-interval 2000
743