Show Interface Access-Group - Allied Telesis AT-IX5-28GPX Manual

IP 4 H A C
V ARDWARE CCESS ONTROL
-
SHOW INTERFACE ACCESS GROUP

show interface access-group

Overview Use this command to display the access groups attached to a port. If an access
group is specified, then the output only includes the ports that the specified access
group is attached to. If no access group is specified then this command displays all
access groups that are attached to the ports that are specified with <port-list>.
Note that access group is the term given for an access-list when it is applied to an
interface.
NOTE
This command will function on your switch in stand-alone mode. but is not supported
when the device forms part of a VCStack.
Syntax
show interface <port-list> access-group
[<3000-3699>|<4000-4699>]
Mode User Exec and Privileged Exec
Example To show all access-lists attached to port1.0.1, use the command:
awplus#
Output Figure 22-1: Example output from the show interface access-group command
Related access-group
Commands
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
L (ACL) C
IST OMMANDS
:
Parameter
<port-list>
access group
<3000-3699>
<4000-4699>
show interface port1.0.1 access-group
Interface port1.0.1
access-group 3000
access-group 3002
access-group 3001
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
Specify the ports to display information. A port-list can be
either:
• a switch port (e.g. port1.0.6) a static channel group (e.g.
sa2) or a dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.6 or port1.0.1-port1.0.6 or po1-po2
• a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.3-1.0.6. Do not mix switch ports, static
channel groups, and LACP channel groups in the same
list.
Select the access group whose details you want to show.
Specifies the Hardware IP access-list.
Specifies the Hardware MAC access-list.
857