Test Interface - Allied Telesis AT-IX5-28GPX Manual

I T C
NTERFACE ESTING OMMANDS

TEST INTERFACE

test interface
Overview This command starts a test on a port or all ports or a selected range or list of ports.
Use the no variant of this command to disable this function. The test duration can
be configured by specifying the time in minutes after specifying a port or ports to
test.
For an example of all the commands required to test switch ports, see the
Examples section in this command. To test the Eth port, set its speed to 100 by
using the command speed 100.
NOTE
performance.
Syntax
test interface {<port-list>|all} [time{<1-60>|cont}]
no test interface {<port-list>|all}
Mode Privileged Exec
Example To test the switch ports in VLAN 1, install loopbacks in the ports, and enter the
following commands:
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus#
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
: Do not run test interface on live networks because this will degrade network
Parameter Description
The ports to test. A port-list can be:
<port-list>
• a switch port (e.g. port1.0.6)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-port1.0.6
• a comma-separated list of the above, e.g.
port1.0.1,port1.0.5-1.0.6
The specified ports must exist.
All ports
all
Keyword entered prior to the value for the time duration of the
time
interface test.
Specifies duration of time to test the interface or interfaces in
<1-60>
minutes (from a minimum of 1 minute to a maximum of 60 minutes).
The default is 4 minutes.
Specifies continuous interface testing until canceled with command
cont
negation.
service test
no spanning-tree rstp enable bridge-forward
interface vlan1
test interface all
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
shutdown
end
345