Auth Two-Step Enable - Allied Telesis AT-IX5-28GPX Manual

A C
UTHENTICATION OMMANDS
-
AUTH TWO STEP ENABLE

auth two-step enable

Overview This command enables a two-step authentication feature on an interface. When
this feature is enabled, the supplicant is authorized in a two-step process. If
authentication succeeds, the supplicant becomes authenticated. This command
will apply the two-step authentication method based on 802.1X-, MAC- or
Web-Authentication.
The no variant of this command disables the two-step authentication feature.
Syntax
auth two-step enable
no auth two-step enable
Default Default.
Mode Interface Configuration for a port.
Usage The single step authentication methods (either user or device authentication) have
a potential security risk:
•
•
Two-step authentication solves this problem by authenticating both the user and
the device. The supplicant will only become authenticated if both these steps are
successful. If the first authentication step fails, then the second step is not started.
Examples To enable the two step authentication feature, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable the two step authentication feature, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
an unauthorized user can access the network with an authorized device, or
an authorized user can access the network with an unauthorized device.
configure terminal
interface port1.0.2
auth two-step enable
configure terminal
interface port1.0.2
no auth two-step enable
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
1065