Mac Address-Table Static - Allied Telesis AT-IX5-28GPX Manual

S C
WITCHING OMMANDS
-
MAC ADDRESS TABLE STATIC

mac address-table static

Overview Use this command to statically configure the MAC address-table to forward or
discard frames with a matching destination MAC address.
Syntax
mac address-table static <mac-addr> {forward|discard} interface
<port> [vlan <vid>]
no mac address-table static <mac-addr> {forward|discard}
interface <port> [vlan <vid>]
Mode Global Configuration
Usage The mac address-table static command is only applicable to Layer 2 switched
traffic within a single VLAN. Do not apply the mac address-table static command
to Layer 3 switched traffic passing from one VLAN to another VLAN. Frames will not
be discarded across VLANs because packets are routed across VLANs. This
command only works on Layer 2 traffic.
Example
awplus#
awplus(config)#
interface port1.0.4 vlan 3
Related clear mac address-table static
Commands
show mac address-table
370 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
The destination MAC address in HHHH.HHHH.HHHH format.
<mac-addr>
The port to display information about. The port may be a switch port
<port>
(e.g. port1.0.4), a static channel group (e.g. sa2), or a dynamic
(LACP) channel group (e.g. po2).
The VLAN ID. If you do not specify a VLAN, its value defaults to vlan 1.
<vid>
configure terminal
mac address-table static 2222.2222.2222 forward
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
C613-50057-01 REV A