Vlan Mode Stack-Local-Vlan - Allied Telesis AT-IX5-28GPX Manual

VLAN C
OMMANDS
- -
VLAN MODE STACK LOCAL VLAN

vlan mode stack-local-vlan

Overview This command enables you to create stack-local-VLANs and use ICMP to monitor
and diagnose issues within specific members of the stack. When a VLAN is added
using this method, all its traffic will be trapped to and processed by the CPU of the
specific local stack member, rather than the CPU of the stack master.
The no variant of this command destroys the specified VLAN.
Syntax
vlan <vid> mode stack-local-vlan <member-id>
no vlan <vid>
Default By default, VLANs are automatically enabled as they are added.
Mode VLAN Configuration
Examples To add a stack-local-VLAN with the VID of 4002 and assign it to stack member 2, use
the following commands:
awplus#
awplus(config)#
awplus(config-vlan)#
To remove VLAN 4002, use the following commands:
awplus#
awplus(config)#
awplus(config-vlan)#
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
<vid>
mode stack-local-
vlan
<member-id>
configure terminal
vlan database
configure terminal
vlan database
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
The VID of the VLAN to be created in the range 2-4094. We
recommend that the first stack-local-vlan be assigned the
number 4001 for the first stack member, then incremented
by one for each stack member. So a stack of four members
would be assigned the following VID numbers:
stack member one VID 4001
stack member two VID 4002
stack member three VID 4003
stack member four VID 4004
Specifies that the new VLAN will function as a stack-local-
VLAN.
Specifies the new stack member ID. Enter a decimal number
in the range 1-8.
vlan 4002 mode stack-local-vlan 2
no vlan 4002
459