Switchport Mode Private-Vlan Trunk Promiscuous - Allied Telesis AT-IX5-28GPX Manual

High availability, high power video surveillance poe switch

Hide thumbs Also See for AT-IX5-28GPX:

Table of Contents

SWITCHPORT MODE PRIVATE

VLAN TRUNK PROMISCUOUS

switchport mode private-vlan trunk

Use this command to enable a port in trunk mode to be promiscuous port for

isolated VLANs.

implementation. Private VLAN trunk ports and GVRP are mutually exclusive.

Use the no variant of this command to remove a port in trunk mode as a

promiscuous port for isolated VLANs. You must first remove the secondary port, or

ports, in trunk mode associated with the promiscuous port with the no switchport

mode private-vlan trunk secondary command.

switchport mode private-vlan trunk promiscuous group <group-id>

no switchport mode private-vlan trunk promiscuous

By default, a port in trunk mode is disabled as a promiscuous port.

Interface Configuration

A port must be put in trunk mode with

can be enabled as a promiscuous port.

To add VLANs to be trunked over the promiscuous port, use the

allowed vlan

To configure the native VLAN for the promiscuous port, use the

When you enable a promiscuous port, all of the secondary port VLANs associated

with the promiscuous port via the group ID number must be added to the

promiscuous port. In other words, the set of VLANs on the promiscuous port must

be a superset of all the VLANs on the secondary ports within the group.

To create the isolated VLANs 2, 3 and 4 and then enable port1.0.2 in trunk

mode as a promiscuous port for these VLANs with the group ID of 3, use the

following commands:

C613-50057-01 REV A

Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch

: Private VLAN trunk ports are not supported by the current AlliedWare Plus GVRP

command. These VLANs can be isolated VLANs, or non-private VLANs.

command. The native VLAN can be an isolated VLAN, or a non-private

AlliedWare Plus™ Operating System - Version 5.4.5-0.x

The group ID is a numeric value in the range 1 to 32 that is

used to associate the promiscuous port with secondary ports.

switchport mode trunk

command before it

switchport trunk