(Access-List Hardware Tcp Udp Filter) - Allied Telesis AT-IX5-28GPX Manual

IP 4 H A C
V ARDWARE CCESS ONTROL
( - TCP UDP
ACCESS LIST HARDWARE

(access-list hardware TCP UDP filter)

Overview Use this ACL filter to add a TCP or UDP filter entry to the current hardware
access-list. The filter will match on any TCP or UDP type packet that has the
specified source and destination IP addresses. The parameter any may be specified
if an address does not matter. If a sequence number is specified, the new filter is
inserted at the specified location. Otherwise, the new filter is added at the end of
the access-list.
The no variant of this command removes a TCP or UDP filter entry from the current
hardware access-list. You can specify the TCP or UDP filter entry for removal by
entering either its sequence number (e.g. no 10), or by entering its TCP or UDP
filter profile without specifying its sequence number.
Note that the sequence number can be found by running the
Hardware ACLs)
Syntax [tcp|udp]
[<sequence-number>]
{deny|permit|send-to-cpu|copy-to-cpu|copy-to-mirror} {tcp|udp}
[<source>|eq <sourceport>|gt <sourceport>|lt <sourceport>|ne
<sourceport>|range <start-range> <end-range>]
[<destination>|eq <destport>|gt <destport>|lt <destport>|ne
<destport>|range <start-range> <end-range>]
no {deny|permit|send-to-cpu|copy-to-cpu|copy-to-mirror}
{tcp|udp} [<source>|eq <sourceport>|gt <sourceport>|lt
<sourceport>|ne <sourceport>|range <start-range> <end-range>]
[<destination>|eq <destport>|gt <destport>|lt <destport>|ne
<destport>|range <start-range> <end-range>]
no <sequence-number>
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
L (ACL) C
IST OMMANDS
)
FILTER
command.
Parameter
<sequence-number>
deny
permit
send-to-cpu
copy-to-cpu
copy-to-mirror
tcp
udp
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
<1-65535>
The sequence number for the filter entry of the
selected access control list.
Access-list rejects packets that match the source and
destination filtering specified with this command.
Access-list permits packets that match the source and
destination filtering specified with this command.
Specify packets to send to the CPU.
Specify packets to copy to the CPU.
Specify packets to copy to the mirror port.
TCP packets.
UDP packets.
show access-list (IPv4
851