Show Interface Status - Allied Telesis AT-IX5-28GPX Manual

I C
NTERFACE OMMANDS

SHOW INTERFACE STATUS

show interface status
Overview Use this command to display the status of the specified interface or interfaces.
Note that when no interface or interfaces are specified then the status of all
interfaces on the device are shown.
Syntax
show interface [<port-list>] status
Examples To display the status of ports 1.0.1 to 1.0.5, use the commands:
awplus#
Table 8-2: Example output from the show interface <port-list> status command
awplus#show interface port1.0.1 -1.0.5 status
Port Name
port1.0.1
port1.0.2
port1.0.3
port1.0.4
338 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
<port-list> The ports to display information about. The port list can be:
• a switch port (e.g. port1.0.6) a static channel group (e.g. sa2) or
a dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.6, or sa1-2, or po1-2
• a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix switch ports,
static channel groups, and dynamic (LACP) channel groups in the
same list
show interface port1.0.1-1.0.4 status
Status
notconnect
notconnect
notconnect
notconnect
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Vlan Duplex Speed Type
1 auto auto 1000BASE-T
1 auto auto 1000BASE-T
1 auto auto 1000BASE-T
1 auto auto 1000BASE-T
C613-50057-01 REV A