Show Running-Config Interface - Allied Telesis AT-IX5-28GPX Manual

F M C
ILE ANAGEMENT OMMANDS
-
SHOW RUNNING CONFIG INTERFACE

show running-config interface

Overview This command displays the current configuration of one or more interfaces on the
device.
Syntax
show running-config interface [<interface-list>] [dot1x|ip
igmp|lacp|mstp|rstp|stp]
Mode Privileged Exec and Global Configuration
Examples To display the current running configuration of your device for ports 1 to 4, use the
command:
awplus#
To display the current running configuration of a device for VLAN 1, use the
command:
awplus#
164 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
<interface-list>
dot1x
lacp
ip igmp
ip multicast
mstp
rstp
stp
show running-config interface port1.0.1-port1.0.4
show running-config interface vlan1
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
The interfaces or ports to display information about. An
interface-list can be:
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by
a hyphen, e.g. vlan2-8, or port1.0.1-1.0.4, or
sa1-2, or po1-2
• a comma-separated list of the above, e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix
interface types in a list
The specified interfaces must exist.
Displays running configuration for 802.1X port
authentication for the specified interfaces.
Displays running configuration for LACP (Link Aggregation
Control Protocol) for the specified interfaces.
Displays running configuration for IGMP (Internet Group
Management Protocol) for the specified interfaces.
Displays running configuration for general multicast
settings for the specified interfaces.
Displays running configuration for MSTP (Multiple
Spanning Tree Protocol) for the specified interfaces.
Displays running configuration for RSTP (Rapid Spanning
Tree Protocol) for the specified interfaces.
Displays running configuration for STP (Spanning Tree
Protocol) for the specified interfaces.
C613-50057-01 REV A