Ipv6 Forwarding - Allied Telesis AT-IX5-28GPX Manual

IP 6 C
V OMMANDS
6
IPV FORWARDING

ipv6 forwarding

Overview Use this command to turn on IPv6 unicast routing for IPv6 packet forwarding.
Execute this command globally on your device prior to issuing
individual interfaces.
Use this no variant of this command to turn off IPv6 unicast routing for IPv6 packet
forwarding. Note IPv6 unicast routing for IPv6 packet forwarding is disabled by
default.
Syntax
ipv6 forwarding
no ipv6 forwarding
Mode Global Configuration
Default IPv6 unicast forwarding is disabled by default.
Usage Enable IPv6 unicast forwarding globally for all interface on your device with this
command. Use the no variant of this command to disable IPv6 unicast forwarding
globally for all interfaces on your device.
IPv6 unicast forwarding allows devices to communicate with devices that are more
than one hop away, providing that there is a route to the destination address. If
IPv6 forwarding is not enabled then pings to addresses on devices that are more
than one hop away will fail, even if there is a route to the destination address.
Examples To enable IPv6 unicast routing, use this command as shown below:
awplus#
awplus(config)#
To disable IPv6 unicast routing, use the no variant of this command as shown
below:
awplus#
awplus(config)#
Related ipv6 enable
Commands
ipv6 multicast-routing
674 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
configure terminal
ipv6 forwarding
configure terminal
no ipv6 forwarding
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
ipv6 enable on
C613-50057-01 REV A