Default-Action - Allied Telesis AT-IX5-28GPX Manual

Q S C
O OMMANDS
-
DEFAULT ACTION

default-action

Overview Sets the action for the default class-map belonging to a particular policy-map. The
action for a non-default class-map depends on the action of any ACL that is applied
to the policy-map.
The default action can therefore be thought of as specifying the action that will be
applied to any data that does not meet the criteria specified by the applied
matching commands.
Use the no variant of this command to reset to the default action of 'permit'.
Syntax
default-action
[permit|deny|send-to-cpu|copy-to-cpu|copy-to-mirror|
send-to-mirror]
no default-action
Default The default is 'permit'.
Mode Policy Map Configuration
Examples To set the action for the default class-map to deny, use the command:
awplus(config-pmap)#
To set the action for the default class-map to copy-to-mirror for use with the
mirror interface
awplus(config-pmap)#
Related mirror interface
Commands
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
permit
deny
send-to-cpu
copy-to-cpu
copy-to-mirror
send-to-mirror
command, use the command:
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
Packets to permit.
Packets to deny.
Specify packets to send to the CPU.
Specify packets to copy to the CPU.
Specify packets to copy to the mirror port.
Specify packets to send to the mirror port.
default-action deny
default-action copy-to-mirror
949