Auth-Mac Method - Allied Telesis AT-IX5-28GPX Manual

A C
UTHENTICATION OMMANDS
-
AUTH MAC METHOD

auth-mac method

Overview This command sets the type of authentication method for MAC-Authentication
that is used with RADIUS on the interface specified in the Interface command
mode.
The no variant of this command resets the authentication method used to the
default method (PAP) as the RADIUS authentication method used by the
MAC-Authentication.
Syntax
auth-mac method [eap-md5|pap]
no auth-mac method
Default The MAC-Authentication method is PAP.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Examples To set the MAC-Authentication method to pap on interface port1.0.2, use the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the MAC-Authentication method to the default on interface port1.0.2,
use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Validation show auth-mac
Commands
show auth-mac interface
show running-config
1070 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Enable EAP-MD5 of authentication method.
eap-md5
Enable PAP of authentication method.
pap
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
auth-mac method pap
no auth-mac method
C613-50057-01 REV A