Gvrp Dynamic-Vlan-Creation - Allied Telesis AT-IX5-28GPX Manual

GVRP C
OMMANDS
- -
GVRP DYNAMIC VLAN CREATION

gvrp dynamic-vlan-creation

Overview Use this command to enable dynamic VLAN creation globally for the switch.
Use the no variant of this command to disable dynamic VLAN creation globally for
the switch.
Syntax
gvrp dynamic-vlan-creation
no gvrp dynamic-vlan-creation
Mode Global Configuration
Default Disabled by default.
Usage You must enable GVRP on both ends of a link for GVRP to propagate VLANs
between links.
You must also enable GVRP globally in Global Configuration mode before enabling
GVRP on an interface in Interface Configuration mode. Both of these tasks must
occur to create VLANs.
NOTE
implementation. VLANs may be numbered 1-4094, but a limit of 400 of these VLANs are
supported.
Examples Enter the following commands for switches with hostnames switch1 and
switch2 respectively, so switch1 propagates VLANs to switch2 and
switch2 propagates VLANs to switch1:
Switch1:
switch1#
switch1(config)#
switch1(config)#
Switch2:
switch2#
switch2(config)#
switch2(config)#
To disable GVRP dynamic VLAN creation on the switch, enter the commands:
awplus#
awplus(config)#
Validation show gvrp configuration
Commands
Related gvrp enable (global)
Commands
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
: There is limit of 400 VLANs supported by the AlliedWare Plus GVRP
configure terminal
gvrp enable
gvrp dynamic-vlan-creation
configure terminal
gvrp enable
gvrp dynamic-vlan-creation
configure terminal
no gvrp dynamic-vlan-creation
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
593