Ipv6 Mld Last-Member-Query-Interval - Allied Telesis AT-IX5-28GPX Manual

MLD MLD S C
AND NOOPING OMMANDS
6 - - -
IPV MLD LAST MEMBER QUERY

ipv6 mld last-member-query-interval

Overview Use this command to configure the interval at which the router sends MLD
group-specific host query messages.
Use the no variant of this command to set this frequency to the default.
Syntax
ipv6 mld last-member-query-interval <milliseconds>
no ipv6 mld last-member-query-interval
Default 1000 milliseconds
Mode Interface Configuration for a specified VLAN interface or a range of VLAN
interfaces.
Example The following example changes the MLD group-specific host query message
interval to 2 seconds:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 mld immediate-leave
Commands
798 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
INTERVAL
Parameter Description
The time delay between successive query messages (in
<milliseconds>
milliseconds). Valid values are from 1000 to 25500 milliseconds.
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
ipv6 enable
ipv6 mld last-member-query-interval 2000
C613-50057-01 REV A