Show Dot1X Statistics Interface - Allied Telesis AT-IX5-28GPX Manual

802.1X C
OMMANDS
1
SHOW DOT X STATISTICS INTERFACE

show dot1x statistics interface

Overview This command shows the authentication statistics for the specified interface,
which may be a static channel (or static aggregator) or a dynamic (or LACP)
channel group or a switch port.
For information on filtering and saving command output, see "Controlling "show"
Command Output" in the
and Configuration
Syntax
show dot1x statistics interface <interface-list>
Mode Privileged Exec
Example See sample output below showing 802.1X authentication statistics for
port1.0.6:
awplus#
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Guide.
Parameter
<interface-list>
show dot1x statistics interface port1.0.6
802.1X statistics for interface port1.0.6
EAPOL Frames Rx: 5 - EAPOL Frames Tx: 16
EAPOL Start Frames Rx: 0 - EAPOL Logoff Frames Rx: 0
EAP Rsp/Id Frames Rx: 3 - EAP Response Frames Rx: 2
EAP Req/Id Frames Tx: 8 - EAP Request Frames Tx: 2
Invalid EAPOL Frames Rx: 0 - EAP Length Error Frames Rx: 0
EAPOL Last Frame Version Rx: 1 - EAPOL Last Frame
Src:00d0.59ab.7037
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
"Getting Started with AlliedWare Plus" Feature Overview
Description
The interfaces or ports to configure. An interface-list can be:
• an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2,
or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
1029