Boot Config-File - Allied Telesis AT-IX5-28GPX Manual

F M C
ILE ANAGEMENT OMMANDS
-
BOOT CONFIG FILE

boot config-file

Overview Use this command to set the configuration file to use during the next boot cycle.
Use the no variant of this command to remove the configuration file.
Syntax
boot config-file <filepath-filename>
no boot config-file
Mode Global Configuration
Usage You can only specify that the configuration file is on a USB storage device if there
is a backup configuration file already specified in Flash. If you attempt to set the
configuration file on a USB storage device and a backup configuration file is not
specified in Flash, the following error message is displayed:
For an explanation of the configuration fallback order, see the
Feature Overview and Configuration
Examples To run the configuration file branch.cfg stored on the device's Flash filesystem
the next time the device boots up, use the commands:
awplus#
awplus(config)#
To remove the configuration file branch.cfg stored on the device's Flash
filesystem the next time the device boots up, use the commands:
awplus#
awplus(config)#
To run the configuration file branch.cfg stored on the switch's USB storage
device filesystem the next time the device boots up, use the commands:
awplus#
awplus(config)#
122 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
<filepath-filename>
% Backup configuration files must be stored in the flash
filesystem
configure terminal
boot config-file flash:/branch.cfg
configure terminal
no boot config-file flash:/branch.cfg
configure terminal
boot config-file usb:/branch.cfg
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
Filepath and name of a configuration file.
The specified configuration file must exist in the
specified filesystem.
Valid configuration files must have a . cfg extension.
Guide.
File Management
C613-50057-01 REV A