Vlan - Allied Telesis AT-IX5-28GPX Manual

VLAN C
OMMANDS

VLAN

vlan
Overview This command creates VLANs, assigns names to them, and enables or disables
them. Specifying the disable state causes all forwarding over the specified VLAN
ID to cease. Specifying the enable state allows forwarding of frames on the
specified VLAN.
The no variant of this command destroys the specified VLANs.
Syntax
vlan <vid> [name <vlan-name>] [state {enable|disable}]
vlan <vid-range> [state {enable|disable}]
vlan {<vid>|<vlan-name>} [mtu <mtu-value>]
no vlan {<vid>|<vid-range>} [mtu]
Default By default, VLANs are enabled when they are created.
Mode VLAN Configuration
Examples
awplus#
awplus(config)#
awplus(config-vlan)#
awplus#
awplus(config)#
awplus(config-vlan)#
Related mtu
Commands
vlan database
show vlan
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
The VID of the VLAN to enable or disable in the range < 1-4094>.
<vid>
The ASCII name of the VLAN. Maximum length: 32 characters.
<vlan-name>
Specifies a range of VLAN identifiers.
<vid-range>
Specifies the Maximum Transmission Unit (MTU) size in bytes, in the
<mtu-value>
range 68 to1500 bytes, for the VLAN.
Sets VLAN into an enable state.
enable
Sets VLAN into a disable state.
disable
configure terminal
vlan database
configure terminal
vlan database
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
vlan 45 name accounts state enable
no vlan 45
451