Auth-Web Method - Allied Telesis AT-IX5-28GPX Manual

A C
UTHENTICATION OMMANDS
-
AUTH WEB METHOD

auth-web method

Overview This command sets the authentication method of Web-Authentication that is used
with RADIUS on the interface specified.
The no variant of this command sets the authentication method to PAP for the
interface specified when Web-Authentication is also used with the RADIUS
authentication method.
Syntax
auth-web method {eap-md5|pap}
no auth-web method
Default The Web-Authentication method is set to PAP by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Example To set the Web-Authentication method to eap-md5 on interface port1.0.2, use
the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Validation show auth-web
Commands
show auth-web interface
show running-config
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Enable EAP-MD5 as the authentication method.
eap-md5
Enable PAP as the authentication method.
pap
configure terminal
interface port1.0.2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
auth-web method eap-md5
1077