Ip Address - Allied Telesis AT-IX5-28GPX Manual

IP A P
DDRESSING AND ROTOCOL

IP ADDRESS

ip address
Overview This command sets a static IP address on an interface. To set the primary IP address
on the interface, specify only ip address<ip-address/m>. This overwrites any
configured primary IP address. To add additional IP addresses on this interface, use
the secondary parameter. You must configure a primary address on the interface
before configuring a secondary address.
NOTE
to view a secondary address configured on an interface. show ip interface brief will
only show the primary address not a secondary address for an interface.
The no variant of this command removes the IP address from the interface. You
cannot remove the primary address when a secondary address is present.
Syntax
ip address <ip-addr/prefix-length> [secondary] [label <label>]
no ip address <ip-addr/prefix-length> [secondary]
no ip address
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Examples To add the primary IP address 10.10.10.50/24 to the interface vlan3, use the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
To add the secondary IP address 10.10.11.50/24 to the same interface, use the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
616 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
C
OMMANDS
: Use show running-config interface not show ip interface brief when you need
Parameter
<ip-addr/prefix-
length>
secondary
label
<label>
configure terminal
interface vlan3
configure terminal
interface vlan3
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
The IPv4 address and prefix length you are assigning to the
interface.
Secondary IP address.
Adds a user-defined description of the secondary IP address.
A user-defined description of the secondary IP address. Valid
characters are any printable character and spaces.
ip address 10.10.10.50/24
ip address 10.10.11.50/24 secondary
C613-50057-01 REV A