Speed - Allied Telesis AT-IX5-28GPX Manual

S C
WITCHING OMMANDS

SPEED

speed
Overview This command changes the speed of the specified port. You can optionally specify
the speed or speeds that get autonegotiated, so autonegotiation is only
attempted at the specified speeds.
To see the currently-negotiated speed for ports whose links are up, use the
interface
default), use the
Syntax
speed {10|100|1000|10000|auto [10][100][1000][10000]}
The following table shows the speed options for each type of port.
Port type
RJ-45 and RJ.5copper ports
supported tri-speed copper SFPs
100Mb fiber SFPs
1000Mb fiber SFPs
10000Mb fiber SFP+
Mode Interface Configuration
Default By default, ports autonegotiate speed (except for 100Base-FX ports which do not
support auto-negotiation, so default to 100Mbps).
Usage Switch ports in a static or dynamic (LACP) channel group must have the same port
speed and be in full duplex mode. Once switch ports have been aggregated into a
channel group, you can set the speed of all the switch ports in the channel group
by applying this command to the channel group.
NOTE
speeds, then only those speeds specified are attempted for autonegotiation.
Examples To set the speed of a tri-speed port to 100Mbps, enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
command. To see the configured speed (when different from the
show running-config
Speed Options (units are Mbps)
auto (default)
10
100
1000
auto (default)
10
100
1000
100
auto (default)
1000
auto (default)
10000
: Note that if multiple speeds are specified after the auto option to autonegotiate
configure terminal
interface port1.0.4
speed 100
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
command.
show
403