Switchport Port-Security - Allied Telesis AT-IX5-28GPX Manual

S C
WITCHING OMMANDS
-
SWITCHPORT PORT SECURITY

switchport port-security

Overview Enables the port-security feature. This feature is also known as the port-based learn
limit. It allows the user to set the maximum number of MAC addresses that each
port can learn.
Use the no variant of this command to disable the port-security feature.
Syntax
switchport port-security
no switchport port-security
Mode Interface Configuration
Examples To enable the port-security feature on port1.0.4, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable port-security feature on port1.0.4, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
406 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
configure terminal
interface port1.0.4
switchport port-security
configure terminal
interface port1.0.4
no switchport port-security
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
C613-50057-01 REV A