A
C
UTHENTICATION
OMMANDS
-
AUTH TIMEOUT REAUTH
PERIOD
auth timeout reauth-period
Overview
This command sets the timer for reauthentication on a given interface. The
re-authentication for the supplicant (client device) is executed at this timeout. The
timeout is only applied if the auth reauthentication command is applied.
Use the no variant of this command to reset the reauth-period parameter to the
default (3600 seconds).
Syntax
auth timeout reauth-period <1-4294967295>
no auth timeout reauth-period
Default
The default reauthentication period for port authentication is 3600 seconds, when
reauthentication is enabled on the port.
Mode
Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Examples
To set the reauthentication period to 1 day for interface port1.0.2, use the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
To reset the reauthentication period to the default (3600 seconds) for interface
port1.0.2, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Validation
show dot1x
Commands
show dot1x interface
show running-config
Related
auth reauthentication
Commands
1062
Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
Description
Seconds.
<1-4294967295>
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
auth timeout reauth-period 86400
no auth timeout reauth-period
C613-50057-01 REV A