Platform Hwfilter-Size - Allied Telesis AT-IX5-28GPX Manual

S C
WITCHING OMMANDS
-
PLATFORM HWFILTER SIZE

platform hwfilter-size

Overview You can use this command to control the configuration of hardware Access
Control Lists (ACLs), which determines the total available number and
functionality of hardware ACLs.
For this command to take effect, you need to reboot the affected service.
One cannot attach an IPv6 ACL to a port if the ACL contains a specified source or
destination IPv6 address or both and the hw-filter size setting is
ipv4-limited-ipv6. If you do so, a diagnostic message will be generated.
Syntax
platform hwfilter-size {ipv4-limited-ipv6|ipv4-full-ipv6}
Default The default mode is ipv4-limited-ipv6.
Mode Global Configuration
Example To configure hardware ACLs to filter IPv4 and IPv6 traffic, use the following
commands:
awplus#
awplus(config)#
Related show platform
Commands
ipv6 access-list (named)
374 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
hwfilter-size
ipv4-full-ipv6
ipv4-limited-ip
v6
configure terminal
platform hwfilter-size ipv4-full-ipv6
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
Configure hardware ACLs command.
Configure hardware ACLs to filter IPv4 traffic, MAC addresses
and IPv6 traffic, including filtering on source or destination
IPv6 addresses, or both; however, this will reduce the total
number of filters available in the hardware table.
Configure hardware ACLs to filter IPv4 traffic, MAC addresses
and IPv6 traffic. Source or destination IPv6 addresses or both
are not filtered.
C613-50057-01 REV A