Dot1X Keytransmit - Allied Telesis AT-IX5-28GPX Manual

802.1X C
OMMANDS
1
DOT X KEYTRANSMIT

dot1x keytransmit

Overview This command enables key transmission on the interface specified previously in
Interface mode.
The no variant of this command disables key transmission on the interface
specified.
Syntax
dot1x keytransmit
no dot1x keytransmit
Default Key transmission for port authentication is enabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Usage Use this command to enable key transmission over an Extensible Authentication
Protocol (EAP) packet between the authenticator and supplicant. Use the no
variant of this command to disable key transmission.
Examples To enable the key transmit feature on interface port1.0.2, after it has been
disabled by negation, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable the key transmit feature from the default startup configuration on
interface port1.0.2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Validation show dot1x
Commands
show dot1x interface
1010 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
configure terminal
interface port1.0.2
dot1x keytransmit
configure terminal
interface port1.0.2
no dot1x keytransmit
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
C613-50057-01 REV A