Debug Gvrp - Allied Telesis AT-IX5-28GPX Manual

GVRP C
OMMANDS

DEBUG GVRP

debug gvrp
Overview Use this command to debug GVRP packets and commands, sending output to the
console.
Use the no variant of this command to turn off debugging for GVRP packets and
commands.
Syntax
debug gvrp {all|cli|event|packet}
no debug gvrp {all|cli|event|packet}
Mode Privileged Exec and Global Configuration
Examples To enable GVRP on interfaces port1.0.1-port1.0.2, enter the commands:
awplus#
awplus(config)#
awplus(config)#
awplus(config-if)#
To disable GVRP on interfaces port1.0.1-port1.0.2, enter the commands:
awplus#
awplus(config)#
awplus(config-if)#
Examples To send debug output to the console for GVRP packets and GVRP commands, and
to enable the display of debug output on the console first, enter the commands:
awplus#
awplus#
awplus(config)#
To send debug output for GVRP packets to the console, enter the commands:
awplus#
awplus#
awplus(config)#
590 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Specifies debugging for all levels.
all
Specifies debugging for commands.
cli
event Specified debugging for events.
Specifies debugging for packets.
packet
configure terminal
gvrp enable
interface port1.0.1-port1.0.2
configure terminal
interface port1.0.1-port1.0.2
terminal monitor
configure terminal
debug gvrp all
terminal monitor
configure terminal
debug gvrp packets
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
gvrp
no gvrp
C613-50057-01 REV A