Dot1X Port-Control - Allied Telesis AT-IX5-28GPX Manual

802.1X C
OMMANDS
1 -
DOT X PORT CONTROL

dot1x port-control

Overview This command enables 802.1X port authentication on the interface specified, and
sets the control of the authentication port. When port-control is set to auto, the
802.1X authentication feature is executed on the interface, but only if the aaa
authentication dot1x command has been issued.
The no variant of this command disables the port authentication on the interface
specified.
Syntax
dot1x port-control {force-unauthorized|force-authorized|auto}
no dot1x port-control
Default 802.1X port control is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Usage Use this command to force a port state. Note that all dot1x commands can only be
applied to switch ports. They cannot be applied to dynamic (LACP) or static
channel groups.
Examples To enable port authentication on the interface port1.0.2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To enable port authentication force authorized on the interface port1.0.2, use
the commands:
awplus#
awplus(config)#
awplus(config-if)#
1014 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
force-unauthorized
force-authorized
auto
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
Force port state to unauthorized.
Specify to force a port to always be in an unauthorized
state.
Force port state to authorized.
Specify to force a port to always be in an authorized state.
Allow port client to negotiate authentication.
Specify to enable authentication on port.
dot1x port-control auto
dot1x port-control force-authorized
C613-50057-01 REV A