VLAN C
OMMANDS
SWITCHPORT MODE TRUNK
switchport mode trunk
Overview
Use this command to set the switching characteristics of the port to trunk.
Received frames are classified based on the VLAN characteristics, then accepted or
discarded based on the specified filtering criteria.
Syntax
switchport mode trunk [ingress-filter {enable|disable}]
Default
By default, ports are in access mode, are untagged members of the default VLAN
(vlan1), and have ingress filtering on.
Mode
Interface Configuration
Usage
A port in trunk mode can be a tagged member of multiple VLANs, and an untagged
member of one native VLAN.
To configure which VLANs this port will trunk for, use the
vlan
Example
awplus#
awplus(config)#
awplus(config-if)#
Validation
show interface switchport
Command
C613-50057-01 REV A
Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
Description
Set the ingress filtering for the frames received.
ingress-filter
Turn on ingress filtering for received frames. This is the default.
enable
Turn off ingress filtering to accept frames that do not meet the
disable
classification criteria.
command.
configure terminal
interface port1.0.3
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
switchport mode trunk ingress-filter enable
switchport trunk allowed
437