Chapter 24: Ipv6 Hardware Access Control List (Acl) Commands; Introduction - Allied Telesis AT-IX5-28GPX Manual

24

Introduction

Overview This chapter provides an alphabetical reference for the IPv6 Hardware Access
Control List (ACL) commands, and contains detailed command information and
command examples about IPv6 hardware ACLs, which are applied directly to
interfaces using the
For information about ACLs, see the
Guide.
To apply ACLs to an LACP channel group, apply it to all the individual switch ports
in the channel group. To apply ACLs to a static channel group, apply it to the static
channel group itself. For more information on link aggregation see the following
references:
•
•
Note that text in parenthesis in command names indicates usage not keyword
entry. For example, ipv6-access-list (named) indicates named IPv6 ACLs entered
as ipv6-access-list <name> where <name> is a placeholder not a keyword.
Note also that parenthesis surrounding ACL filters indicates the type of ACL filter
not the keyword entry in the CLI, such as (ipv6 access-list standard IPv6 filter)
represents command entry in the format shown in the syntax
[<sequence-number>] {deny|permit} {<IPv6-source-address/prefix-length>|any}.
NOTE
903 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Access Control List
(ACL) Commands
ipv6 traffic-filter
the Link Aggregation Feature Overview and Configuration
Link Aggregation Commands
: Hardware ACLs will permit access unless explicitly denied by an ACL action.
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
IPv6 Hardware
command.
ACL Feature Overview and Configuration
Guide.
C613-50057-01 REV A