Show Interface Memory - Allied Telesis AT-IX5-28GPX Manual

S C M
YSTEM ONFIGURATION AND

SHOW INTERFACE MEMORY

show interface memory
Overview This command displays the shared memory used by either all interfaces, or the
specified interface or interfaces. The output is useful for diagnostic purposes by
Allied Telesis authorized service personnel.
For information on filtering and saving command output, see "Controlling "show"
Command Output" in the
and Configuration
Syntax
show interface memory
show interface <port-list> memory
Mode User Exec and Privileged Exec
Example To display the shared memory used by all interfaces, use the command:
awplus#
To display the shared memory used by port1.0.1 and port1.0.5 to port1.0.6, use the
command:
awplus#
Output Figure 5-7:
232 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
C
ONITORING OMMANDS
Guide.
Parameter Description
The ports to display information about. The port list can be:
<port-list>
• a switch port (e.g. port1.0.4) a static channel group (e.g. sa2)
or a dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.4, or sa1-2, or po1-2
• a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix switch ports,
static channel groups, and dynamic (LACP) channel groups in the
same list
show interface memory
show interface port1.0.1,port1.0.5-1.0.6 memory
Example output from the show interface <port-list> memory
command
awplus#show interface port1.0.1,port1.0.5-1.0.6 memory
Vlan blocking state shared memory usage
---------------------------------------------
Interface shmid
port1.0.1 393228
port1.0.5 491535
port1.0.6 557073
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
"Getting Started with AlliedWare Plus" Feature Overview
Bytes Used
512
512
512
nattch Status
1
1
1
C613-50057-01 REV A