Mls Qos Map Premark-Dscp To - Allied Telesis AT-IX5-28GPX Manual

Q S C
O OMMANDS
-
MLS QOS MAP PREMARK DSCP TO

mls qos map premark-dscp to

Overview This command configures the premark-dscp map. It is used when traffic is
classified by a class-map that has
the map determines new QoS settings for the traffic.
The no variant of this command resets the premark-dscp map to its defaults. If no
DSCP is specified then all DSCP entries will be reset to their defaults.
Syntax
mls qos map premark-dscp <0-63> to {[new-dscp <0-63>][new-cos
<0-7>] [new-bandwidth-class {green|yellow|red}]}
no mls qos map premark-dscp [<0-63>]
Mode Global Configuration
Usage With the
enables you to make the following changes:
•
•
NOTE
If you attempt to remap both the DSCP and another setting, only the DSCP remap will
take effect.
968 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
premark-dscp <0-63>
new-dscp <0-63>
new-cos <0-7>
new-bandwidth-class
green
yellow
red
trust dscp command set, this command (mls qos map premark-dscp)
remap the DSCP (leaving the other settings unchanged)
remap any or all of CoS, output queue, or bandwidth class values (leaving the
DSCP unchanged)
:
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
trust dscp configured. Based on a lookup DSCP,
Description
The DSCP value on ingress.
The DSCP value that the packet will have on egress.
If unspecified, this value will remain the DSCP ingress
value.
The CoS value that the packet will have on egress.
If unspecified, this value will retain its value on ingress.
Modify Egress Bandwidth-class.
If unspecified, this value will be set to green.
Egress Bandwidth-class green (marked down
Bandwidth-class).
Egress Bandwidth-class yellow (marked down
Bandwidth-class).
Egress Bandwidth-class red (marked down Bandwidth-
class).
C613-50057-01 REV A