(Ipv6 Access-List Extended Tcp Udp Filter) - Allied Telesis AT-IX5-28GPX Manual

IP 6 S A C
V OFTWARE CCESS ONTROL
( 6 - TCP UDP
IPV ACCESS LIST EXTENDED

(ipv6 access-list extended TCP UDP filter)

Overview Use this ACL filter to add a filter entry for an IPv6 source and destination address
and prefix, with a TCP (Transmission Control Protocol) or UDP (User Datagram
Protocol) source and destination port specified, to the current extended IPv6
access-list. If a sequence number is specified, the new entry is inserted at the
specified location. Otherwise, the new entry is added at the end of the access-list.
The no variant of this command removes a filter entry for an IPv6 source and
destination address and prefix, with a TCP or UDP source and destination port
specified, from the current extended IPv6 access-list. You can specify the filter
entry for removal by entering either its sequence number, or its filter entry profile.
Syntax [tcp|udp]
[<sequence-number>] {deny|permit} {tcp|udp}
{<ipv6-source-address/prefix>|any} {eq <sourceport>|lt
<sourceport>|gt <sourceport>|ne <sourceport>}
{<IPv6-destination-address/prefix>|any} {eq <destport>|lt
<destport>|gt <destport>|ne <destport>} [log]
no {deny|permit} {tcp|udp} {<ipv6-source-address/prefix>|any}
{eq <sourceport>|lt <sourceport>|gt <sourceport>|ne
<sourceport>}} {<IPv6-destination-address/prefix>|any} {eq
<destport>|lt <destport>|gt <destport>|ne <destport>} [log]
no <sequence-number>
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
L (ACL) C
IST OMMANDS
)
FILTER
Parameter
<sequence-number> <1-65535>
deny
permit
tcp
udp
<ipv6-source-
address/prefix>
any
eq
lt
gt
ne
<sourceport>
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
The sequence number for the filter entry of the selected
access control list.
Specifies the packets to reject.
Specifies the packets to accept.
TCP packet.
UDP packet.
IPv6 source address, or local address.
The IPv6 address uses the format X:X::X:X/Prefix-Length. The
prefix-length is usually set between 0 and 64.
Any source address or local address.
Equal to.
Less than.
Greater than.
Not equal to.
The source port number, specified as an integer between 0
and 65535.
937