Introduction; Access Control List - Allied Telesis AT-IX5-28GPX Manual

22

Introduction

Overview This chapter provides an alphabetical reference of IPv4 Hardware Access Control
List (ACL) commands. It contains detailed command information and command
examples about IPv4 hardware ACLs, which are applied directly to interfaces using
the
To apply ACLs to an LACP channel group, apply it to all the individual switch ports
in the channel group. To apply ACLs to a static channel group, apply it to the static
channel group itself.
•
•
•
Sub-modes Many of the ACL commands operate from sub-modes that are specific to particular
ACL types. The following table shows the CLI prompts at which ACL commands are
entered.
Table 22-1: IPv4 Hardware Access List Commands and Prompts
Command Name
show interface access-group
show access-list (IPv4 Hardware ACLs)
show interface access-group
820 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch

Access Control List

(ACL) Commands
access-group command
Text in parenthesis in command names indicates usage not keyword entry.
For example, access-list hardware (named) indicates named IPv4 hardware
ACLs entered as access-list hardware <name> where <name> is a
placeholder not a keyword.
Parenthesis surrounding ACL filters indicates the type of ACL filter not the
keyword entry in the CLI, such as (access-list standard numbered filter)
represents command entry in the format shown in the syntax
[<sequence-number>] {deny|permit} {<source>|host
<host-address>|any}.
Software ACLs will deny access unless explicitly permitted by an ACL
action.
Command Mode
Privileged Exec
Privileged Exec
Privileged Exec
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
IPv4 Hardware
Prompt
awplus#
awplus#
awplus#
C613-50057-01 REV A