Q
S C
O
OMMANDS
-
MLS QOS MAP COS
QUEUE TO
mls qos map cos-queue to
Overview
Use this command to set the default CoS to egress queue mapping. This is the
default queue mapping for packets that do not get assigned an egress queue via
any other QoS functionality.
Use the no variant of this command to reset the cos-queue map back to its default
setting. The default mappings for this command are:
Syntax
mls qos map cos-queue <cos-priority> to <queue-number>
no mls qos map cos-queue
Mode
Global Configuration
Examples
To map CoS 2 to queue 0, use the command:
awplus#
awplus(config)#
To set the cos-queue map back to its defaults, use the command:
awplus#
awplus(config)#
Related
show mls qos interface
Commands
C613-50057-01 REV A
Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
CoS Priority :
--------------------------------
CoS QUEUE:
Parameter
Description
CoS priority value. Can take a value between 0 and 7.
<cos-priority>
Queue number. Can take a value between 0 and 7.
<queue-number>
configure terminal
mls qos map cos-queue 2 to 0
configure terminal
no mls qos map cos-queue
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
0 1 2 3 4 5 6 7
2 0 1 3 4 5 6 7
967