Police Single-Rate Action - Allied Telesis AT-IX5-28GPX Manual

Q S C
O OMMANDS
-
POLICE SINGLE RATE ACTION

police single-rate action

Overview Configures a single-rate policer for a class-map.
Syntax
police
single-rate <cir>
<cbs> <ebs> action {drop-red|remark-transmit}
Mode Policy Map Class Configuration
Usage You can use a policer to meter the traffic classified by the class-map and assign it
to one of three bandwidth classes.
The bandwidth classes are green (conforming), yellow (partially-conforming), and
red (non-conforming). A single-rate policer is based on three values. These are the
average rate, minimum burst and maximum burst.
Using an action of drop-red means that any packets classed as red are discarded.
NOTE
This command will not take effect when applied to a class-map that attaches to a
channel group whose ports span processor instances.
Note that the
configured on the same class-map as the policer, then the remark-map will apply
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Specify the Committed Information Rate (CIR) (1-40000000 kbps).
<cir>
Specify the Committed Burst Size (CBS) (0-16777216 bytes).
<cbs>
Specify a Excess Burst Size (EBS) (0-16777216 bytes).
<ebs>
Specify the action if the rate is exceeded.
action
drop-red
remark-
transmit
Color Definition
The traffic rate is less than the average rate and minimum burst.
green
The traffic rate is between the minimum burst and the maximum
yellow
burst.
The traffic rate exceeds the average rate and the maximum burst.
red
:
remark-map
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Drop the red packets.
Modify the packets using the remark map,
then transmit. You can configure the remark
map using the
does not only apply to red traffic. If a remark-map is
remark-map command.
971