Copy Debug - Allied Telesis AT-IX5-28GPX Manual

F M C
ILE ANAGEMENT OMMANDS

COPY DEBUG

copy debug
Overview This command copies a specified debug file to a destination file. Specify whether
the destination is Flash or USB when saving the software to the local filesystem.
Syntax
copy debug {<destination-name>|debug|flash|nvs|scp|tftp|usb}
{<source-name>|debug|flash|nvs|scp|tftp|usb}
Mode Privileged Exec
Example To copy debug output to a USB storage device with a filename my-debug, use the
following command:
awplus#
Output Figure 3-2:
Related delete debug
Commands
move debug
130 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
<destination-name>
<source-namee>
copy debug usb:mydebug
CLI prompt after entering the copy debug command
Enter source file name []:
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
The filename and path where you would like the debug
output saved. See Introduction
syntax.
The filename and path where the debug output originates.
See Introduction on page 117 for valid syntax.
on page 117 for valid
C613-50057-01 REV A