Dot1X Timeout Tx-Period - Allied Telesis AT-IX5-28GPX Manual

802.1X C
OMMANDS
1 -
DOT X TIMEOUT TX PERIOD

dot1x timeout tx-period

Overview This command sets the transmit timeout for the authentication request on the
specified interface.
The no variant of this command resets the transmit timeout period to the default
(30 seconds).
Syntax
dot1x timeout tx-period <1-65535>
no dot1x timeout tx-period
Default The default transmit period for port authentication is 30 seconds.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Usage Use this command to set the interval between successive attempts to request an
ID.
Examples To set the transmit timeout period to 5 seconds on interface port1.0.2, use the
commands:
awplus#
awplus(config)#
awplus(config-if)#
To reset transmit timeout period to the default (30 seconds) on interface
port1.0.2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Validation show dot1x
Commands
show dot1x interface
1016 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Seconds.
<1-65535>
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
dot1x timeout tx-period 5
no dot1x timeout tx-period
C613-50057-01 REV A