Dot1X Control-Direction - Allied Telesis AT-IX5-28GPX Manual

802.1X C
OMMANDS
1 -
DOT X CONTROL DIRECTION

dot1x control-direction

Overview This command sets the direction of the filter for the unauthorized interface.
If the optional in parameter is specified with this command then packets entering
the specified port are discarded. The in parameter discards the ingress packets
received from the supplicant.
If the optional both parameter is specified with this command then packets
entering (ingress) and leaving (egress) the specified port are discarded. The both
parameter discards the packets received from the supplicant and sent to the
supplicant.
The no variant of this command sets the direction of the filter to both. The port will
then discard both ingress and egress traffic.
Syntax
dot1x control-direction {in|both}
no dot1x control-direction
Default The authentication port direction is set to both by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Example s To set the port direction to the default ( both) for port1.0.2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the port direction to in for port1.0.2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Validation show dot1x
Commands
show dot1x interface
show auth-mac interface
show auth-web interface
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter
in
both
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
Discard received packets from the supplicant (ingress
packets).
Discard received packets from the supplicant (ingress
packets) and transmitted packets to the supplicant (egress
packets).
no dot1x control-direction
dot1x control-direction in
1005