Ip Igmp Querier-Timeout - Allied Telesis AT-IX5-28GPX Manual

IGMP IGMP S C
AND NOOPING OMMANDS
-
IP IGMP QUERIER TIMEOUT

ip igmp querier-timeout

Overview Use this command to configure the timeout period before the device takes over as
the querier for the VLAN interface after the previous querier has stopped querying.
Use the no variant of this command to restore the default.
Syntax
ip igmp querier-timeout <timeout>
no ip igmp querier-timeout
Default The default timeout interval is 255 seconds.
Mode Interface Configuration for a VLAN interface.
Usage This command applies to VLAN interfaces configured for IGMP. The timeout value
should not be less than the current active querier's general query interval.
Example The following example configures the device to wait 130 seconds from the time it
received the last query before it takes over as the querier for the VLAN interface
vlan20:
awplus#
awplus(config)#
awplus(config-if)#
Validation show ip igmp interface
Commands
show running-config
Related ip igmp query-interval
Commands
748 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
IGMP querier timeout interval value in seconds, in the range <1-
<timeout>
65535>.
configure terminal
interface vlan20
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
ip igmp querier-timeout 130
C613-50057-01 REV A