(Ipv6 Access-List Named Icmp Filter) - Allied Telesis AT-IX5-28GPX Manual

IP 6 H A C
V ARDWARE CCESS ONTROL
( 6 - ICMP
IPV ACCESS LIST NAMED

(ipv6 access-list named ICMP filter)

Overview Use this ACL filter to add a filter entry for an IPv6 source and destination address
and prefix, with ICMP (Internet Control Message Protocol) packets, to the current
named IPv6 access-list. If a sequence number is specified, the new entry is inserted
at the specified location. Otherwise, the new entry is added at the end of the
access-list.
Note that specifying the send-to-cpu parameter could result in EPSR healthcheck
messages and other control packets being dropped.
As an optional parameter vlan can be matched for tagged (802.1q) packet.
The no variant of this command removes a filter entry for an IPv6 source and
destination address and prefix, with ICMP (Internet Control Message Protocol)
packets, from the current named IPv6 access-list. You can specify the filter entry for
removal by entering either its sequence number, or its filter entry profile.
NOTE
Syntax [ip|icmp]
[<sequence-number>
{deny|permit|send-to-cpu|send-to-mirror|copy-to-cpu|copy-to-mi
rror} {ipv6|icmp}
{<ipv6-source-address/prefix-length>|<ipv6-source-address>
<ipv6-source-wildcard>|host <ipv6-source-host>|any}
{<ipv6-destination-address/prefix-length>|<ipv6-destintation-a
ddr> <ipv6-destination-wildcard>|host
<ipv6-destination-host-address>|any} [<icmp-type>][vlan
<1-4094>]
no
[<sequence-number>]{deny|permit|send-to-cpu|send-to-mirror|cop
y-to-cpu|copy-to-mirror}
{ip|icmp}{<ipv6-source-address/prefix-length>|<ipv6-source-add
ress> <ipv6-source-wildcard>|host <ipv6-source-host>|any}
{<ipv6-destination-address/prefix-length>|<ipv6-destination-ad
dress> <ipv6-destination-wildcard>|host
<ipv6-destination-host-address>|any} [<icmp-type>][vlan
<1-4094>]
no [<sequence-number>]
908 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
L (ACL) C
IST OMMANDS
)
FILTER
: Hardware ACLs will permit access unless explicitly denied by an ACL action.
Parameter
<sequence-number>
deny
permit
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
<1-65535>The sequence number for
the filter entry of the selected
access control list.
Specifies the packets to reject.
Specifies the packets to permit.
C613-50057-01 REV A