Auth Timeout Quiet-Period - Allied Telesis AT-IX5-28GPX Manual

A C
UTHENTICATION OMMANDS
-
AUTH TIMEOUT QUIET PERIOD

auth timeout quiet-period

Overview This command sets the time period for which the authentication request is not
accepted on a given interface, after the authentication request has failed an
authentication.
Use the no variant of this command to reset quiet period to the default (60
seconds).
Syntax
auth timeout quiet-period <1-65535>
no auth timeout quiet-period
Default The quiet period of port authentication is 60 seconds.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Examples To set the quiet period to 10 for interface port1.0.2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
To reset the quiet period to the default (60 seconds) for interface port1.0.2, use
the following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Seconds.
<1-65535>
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
auth timeout quiet-period 10
no auth timeout quiet-period
1061